The bike leg of an IRONMAN 70.3 is the biggest pacing decision of the day. 90 km. Two and a half hours in the saddle. Every watt you misjudge shows up directly in the run: five watts too hard for the first hour can cost you 30 minutes on the half marathon. Ride too conservatively, on the other hand, and you leave minutes on the course you will never get back.

The good news is that the pacing math is simple. You need three numbers: FTP, your target finish time, and the course profile. Below are the percentages that work, whether you are aiming for 4:30 or 7:00.

How much FTP: data instead of guesswork

Data from coaches working with hundreds of age-group athletes (MyProCoach, Phazon, Scientific Triathlon) is consistent. The wattage you can hold for 90 km depends mainly on your target finish time.

70.3 finish time% FTP% threshold heart rateRPE (1 to 10)
Under 5:00h (top age-groupers)83 to 84%88 to 92%6/10
5:00 to 6:00h (mid-pack)80 to 83%84 to 88%5/10
6:00 to 8:00h (finishing)77 to 80%81 to 85%4 to 5/10
Professionalsup to 90%above 92%6 to 7/10

Source: MyProCoach, Phazon Triathlon, Scientific Triathlon EP#131.

A concrete example. FTP of 280 W, targeting 5:15. The 80 to 83% range applies, which is 224 to 232 W average over 90 km. If you leave T1 and your power meter reads 260 W in the first 20 minutes, slow down. Now. Every minute above your zone is a debt you repay three times over on the run.

TSS: the second number that decides your race

Average power alone is not enough. The second metric is TSS, Training Stress Score, a measure of training load. For a 70.3, the safe range is 165 to 170 TSS. Go above that and you are leaving too much on the bike course, not the run.

In practice: if your power meter or bike computer (Garmin Edge, Wahoo Elemnt) shows a TSS of 120 after 50 km, you are riding too hard. You have 40 km left and a remaining budget of only 50 TSS. Back off by 5 to 10 watts.

The first hour: where most riders blow it

Ninety percent of age-group athletes burn through their first 60 minutes too fast, an observation confirmed across pacing analyses on TrainingPeaks. Fresh off the swim, still running on adrenaline through transition, on the aero bars for the first time that day, watts run 15 to 20% too high. It feels easy. You are passing people. Power climbs without effort.

That feeling is the trap.

The first hour rule: you should feel like you are riding too slowly. If the first 30 km does not feel a little frustrating, you are already riding too hard. Coaches at MyProCoach suggest aiming for the bottom of your wattage range through the first hour and the top of it through the second, the opposite of what most age-groupers actually do.

The second mistake is reacting to being overtaken. When someone from your age group passes you, the instinct is to speed up. Do not. Ride your own plan, not someone else’s. The rider who just passed you will hand that position back in 60 km, once their power runs out.

Hills: how to adjust your watts

On courses like 70.3 Lanzarote or 70.3 Mallorca, the standard “hold your average” strategy does not work. The profile forces an uneven effort.

The rule: do not exceed 110% of your target power on a climb. If your target average is 230 W, cap climbs at 255 W. Every minute spent at 270 to 280 W on a rise builds lactate you will pay for on the run.

On descents, pedal actively rather than coasting. Even 150 to 180 W on a 5% descent saves two to three minutes over 90 km compared with freewheeling. That detail is the gap between finishing under 5:00 and finishing at 5:20.

On the flat section after a climb, return to your target average, not the top of your range. The temptation to “claw back” seconds on the flat is strong, but the lactate from the climb stays in your muscles for the next 20 minutes.

NP versus AP: which number to read

Your power meter shows two figures.

  • AP (Average Power), the arithmetic mean of watts across the whole ride
  • NP (Normalized Power), a weighted average that accounts for how variable the effort was (more time at higher watts pushes NP up)

For a 70.3, NP is the more accurate measure of biological fatigue. The practical strategy is to keep NP inside your FTP percentage range. The gap between NP and AP, the variability index (VI), should sit close to 1.05 on a flat course and up to 1.10 on a hilly one.

If you finish the ride with a VI of 1.15 or higher, you surged too much. That is the classic error: hammering the climbs, coasting the descents. Your power budget gets spent unevenly.

Fuelling and watts

Above 80% of FTP, your body burns 60 to 90 g of carbohydrate per hour. Drink only water and you hit an energy deficit after 90 minutes. Watts start dropping even though the effort feels the same.

The minimum for a 70.3 is 60 g of carbohydrate per hour, split between gels (two Maurten 100 gels give 50 g) and an isotonic drink (500 ml of Precision PF 30 gives 30 g). In hot conditions, above 28°C (82°F), raise that to 80 to 90 g per hour. That requires training your gut to tolerate it beforehand.

Three pacing mistakes age-groupers keep making

First: riding by feel, with no power meter. Perceived effort lies on fresh legs. The first 20 km can feel like a 5 out of 10 while the watts read 95% of FTP. Without an objective number, you burn through your energy reserves.

Second: an inflated target FTP. Test your FTP once in January and base the whole season on that number. In reality, FTP shifts by 5 to 10% depending on form, sleep and stress. Retest every six to eight weeks, or at least adjust your percentages based on how training sessions are going.

Third: pacing off other riders on the course. “That rider on the Canyon Speedmax weighs the same as me, so I can hold their wheel.” Not true. Their FTP might be 320 W against your 280 W. Your pacing plan is yours alone.

Verdict: math, not magic

Pacing the bike leg of a 70.3 is not a matter of talent. It comes down to applying three numbers: FTP, target finish time and course profile. Ride with a power meter and hold your percentage range, and you finish your 70.3 in the time you planned, with something left for the run.

Ride by feel, and you burn through the first 30 km, then spend the next 21 km of running fighting yourself.

The choice is yours. But the data is clear: holding 80 to 83% of FTP over 90 km is not conservatism, it is rational pacing. Save your seconds for the run, not the first lap of the bike course.

The next piece of the same puzzle is Run-Walk Pacing for an IRONMAN Marathon. When the training is ready for a start line, Racelify lists triathlons worldwide.